|Phase||Ingredients for a 70 gr mold||Quantity|
|A||melt & pour soap base, clear||67 gr|
|A||blue 15 oxide, cosmetic pigment||0,03 gr ~ a pinch|
|B||guaiac essential oil||2 gr|
|B||ravensara aromatica essential oil||25 drops|
|B||sage essential oil||7 drops|
Clean the worktop, mold and all utensils you work with, details in the general safety guidelines.
Place the diced soap base (cut as small as possible, about 1 cm) in a heat-resistant container (Berzelius beaker or a stainless steel cup) and melt in a water bath. When melted, add the pigment and mix well until completely dispersed.
Add the ingredients from phase B, mix well and remove the container from the water bath.
It is poured in one motion into the prepared mold. Surface air bubbles can be removed by spraying with a little alcohol if necessary.
Leave the soap mold on a flat surface. After approximately 4 hours the soap is removed from the mold and left to dry until the next day, in an environment as dry as possible. After 24 hours, the soap can be used.
If the environment in which the soap is stored has medium or high humidity, "dew" may appear on its surface and a gelatinous layer may form. This is a natural phenomenon that occurs in all melt & pour type natural soaps.
To avoid this phenomenon, it is advisable to wrap the soap in a foil or store it in a hermetically sealed container.
When preparing a recipe, after removing the soap from the form/mold, it is stored in a dry place, but if it will not be used in soon, it will be wrapped in plastic foil.
This formula was developed by Elemental's qualified staff. The recipes are intended to exemplify the use of products marketed by Elemental and are believed to be accurate, however, Elemental assumes no liability or risk associated with the use of its products for the preparation and evaluation of the recipe as the conditions of preparation and use are beyond its control. The Elemental customer must ensure that the reproduction of the formulation does not infringe any intellectual property rights and that it complies with the specific rules and regulations in force. The person who prepares the recipe must refer to the safety data sheets to ensure the safe handling of all raw materials and bears full responsibility for ensuring the safe and correct use and storage of all materials procured and used. Assessments of the safety, stability, regulatory compliance and suitability of this recipe, methods and the finished product are the sole responsibility of the user and/or the legal entity placing the product on the market. Elemental is not liable for any damages resulting from the use of this information, and assumes no responsibility for misuse of selected materials, formula or method, in whole or in part.